Printable PDFWall Mount Fixed Bracket Instructions Printable PDF

LOCATING THE STUDS IN THE WALL

The most important part is to locate a strong place inside the wall to mount the Brackets to (drywall or lath plaster is not strong enough). Alvas recommends mounting the Brackets to wood studs inside the wall, which is the most common type of installation. Anything other than wood studs may require alternate installation instructions.

Walls will vary in construction and consequently so will the type of fastener needed to mount the Channel. The screws provided will work well on most walls with wood studs. Wood studs are normally set apart at 16” on center, vertically. Each Bracket will need to be installed into a stud, which is why Alvas Standard Barres have hole/Bracket spacing in multiples of 16” apart.

The first thing you want to do is to plot your wall. Use a stud finder to locate exactly where the wood studs are inside the wall. Then make vertical marks on the wall where the studs are so you know where the Brackets can be installed.

IF USING A PRE-DRILLED BARRE

The distance between the holes in the Wood Barre will designate the location of the Brackets on the wall. Use a tape measure to determine, based on the location of the studs, where you want to have your Brackets. Mark these distances on the wall and use a level to make perfectly vertical lines at the marks. (Vertical lines should start at 29” from the floor and go up the wall about 15”).

IF USING A CUSTOM BARRE WITH NO HOLES

Use a tape measure to take accurate measurements between the marks on the wall and mark these distances on the Wood Barre as shown in illustration. Mark these distances on the wall and use a level to make perfectly vertical lines at the marks. (Vertical lines should start at 29” from the floor and go up the wall about 15”).

wm-fixed-bracket-diagram1
wm-fixed-bracket-diagram2

To drill the holes in the Wood Barre, first use a 3/8” drill and make all holes 7/8” deep (NO DEEPER). Then go back to each hole with a smaller 5/16” drill and, in the same hole, go down another 5/8” making the total depth 1-1/2”. It is important that these holes are exactly parallel to each other and perpendicular to the Wood Barre. (A drill press makes this easier) DO NOT DRILL THROUGH THE BARRE!

ASSEMBLING THE BRACKETS INTO THE BARRES
Hand-screw all Fixed Brackets into the Wood Barre clockwise until the shoulders of the Bracket touch the wood. An additional 1/2 turn (NO MORE) may be necessary to straighten out the Brackets and make them perpendicular to the Wood Barre, and parallel to each other.

bracket-assembly-diagram

MOUNTING THE BARRE ASSEMBLY TO THE WALLHold Barre assembly up with the Brackets touching the wall at the height you desire the Barre to be. Mark on the wall the places where the holes will be drilled for the Bracket mounting screws. Drill these holes slightly smaller than the screws provided, to assure a snug fit. Secure the Barre assembly to the wall.

fixed-bracket-side-view-diagram

Printable PDFWall Mount Fixed Bracket Instructions Printable PDF

ASSEMBLY AND CARE DISCLAIMER

Alvas Barres Floors Mirrors (“Alvas”) encourages customers to have all Alvas products professionally installed and maintained by an experienced and licensed contractor. Alvas provides installation and care/maintenance instructions for clients’ information and convenience only. Alvas cannot and does not make any representations, warranties or guarantees with respect to the installation, care or maintenance of Alvas products or any damage or defects resulting from the same. Improper installation, care or maintenance of any barre, floor, mirror, or other Alvas product may invalidate the product’s warranty or guarantee, if any. Alvas reserves the right to deny customer claims made pursuant to any such warranty or guarantee if Alvas determines the damage or defect to the product is the result of improper installation, care, maintenance or use of the product.