|
| |
| All Mirror
Panels come with two pre-installed aluminum angle brackets for wall
mounting. Remove these brackets if you are using the Alvas mirror
base. Keep the clear plastic sheet over the mirror face to help
protect it while mounting the bases. |
| |
| 1) Attach Bumper
Guard to tabs in 'T' Bars using the 4 Countersink Bolts provided.
Align rounded corner of Bumper Guard to rounded corner of tab for
Bumper Guard. Tighten these Countersink Bolts completely with a
Phillips head screwdriver. |
| |
| 2) Have a helper
hold Mirror Panel centered on base. Side edges of Mirror Panel should
be centered and flush with vertical side edges of 'T' Bar. |
| |
| 3) Drill drive
four 1 1/2" Self-drilling Screws through the holes in the vertical
square tube of 'T' Bar into the Mirror Panel's aluminum frame. Tighten
screws up to the point where sponge pads on 'T' Bar begin to slightly
compress. Be careful not to over tighten screws to avoid stripping.
Do not press excessively on mirror surface. |
| |
| 4) Plastic
protective cover may now be removed from Mirror Panel. |
| |
| 5) Repeat process
of drill driving through hole in Bumper Guard using 3/4" Self-drilling
Screw. Secure Bumper Guard to bottom of Mirror Panel frame using
the one 3/4" Self-drilling Screw provided. Do not over tighten
screw. |
